WB stone-chip protection – over-coatable

WB STONE-CHIP PROTECTION (OVERCOATABLE)


presto AQUA Stone-Chip Protection is a water-based stone chip and corrosion protection for the car undersides and visible parts. Because of it's solvent-free formulation it is espacially environmentally friendly. It forms a resistant elastic protective coat against stone chipping. Can be coated after 60 minutes.

For use on:
Cars, caravans, tanks, boats, lorries, spoilers and sills.

The product is available in 1 litre spray gun can.

QUALITY AND PROPERTIES

  • Excellent corrosion protection
  • Environmentally friendly because of solvent free
  • Can be applied on epoxy primers, polyurethane fillers, hardened paints and directly onto sheet
  • Long-lasting elasticity
  • Excellent adhesion
  • Very resistant to weather influences, splash water and abrasion, also to weak acids and bases
  • Cleaning: fresh material with warm water, dry material mechanically

PHYSICAL AND CHEMICAL DATA

  • Basis:aqueous synthetic dispersion
  • Colour:black
  • Smell:characteristic
  • Temperature resistance:-25°C up to +80°C
  • Yield:6 – 7 m²/l
  • Working temperature:+5°C up to +30°C, best results at room temperature
  • Drying time: (20°C, 65% RV):can be covered after approx. 1 h.
    The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
  • Storage stability:
    1 year if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
  • Size: 
    spray gun can, maximum nominal volume 1000 ml
  • VOC:94 g/l

ENVIRONMENT AND LABELLING

Environmentally compatible: MOTIP DUPLI is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.

Disposal: Please mind the residue inside the containers. Completely emptied containers can be used for recycling. If cans are not emptied, they should be disposed off as “special refuse”.

Labelling: All products of MOTIP DUPLI comply with the current status of their labelling regulations. Classification and distinction takes place by the presently legal form of the Globally Harmonized System of Classification and Labelling of Chemicals (GHS) or rather by CLP 1272/2008/EG regulations. Our safety data sheets comply with the current form of REACH 1907/2006/EG, article 31 und appendix II,

USING INSTRUCTIONS

The most presto spray paints have a so-called no-spray ring or a tamper-proof cap. This is to avoid unauthorized use. Please see the corresponding advises on the cap or on the label.
Before use, carefully read and observe the warning texts on the labels!

Application spray gun can:

  • For best reslts bring can to room temperature.
  • The product is ready-to-use, no thinner necessary.
  • Clean the spray gun with warm water.
  • Do not apply in conditions of relative humidity greater than 80%.

TIPS FOR SPRAY PAINTING

Protect the object and the surrounding area from spray mist. When painting small areas it is recommended that a piece of card is used as a mask, with a hole cut in it slightly larger than the area to be sprayed. The mask should be held 1 to 2 cm from the surface. With this method, the mainly part of the spray mist is brought under control. It recommends to mask parts not to be lacquered, to protect the surrounding against the spray mist.

The aerosol can should have room temperature.

Temperature should range between +10°C and +25°C, max. air humidity 60 %.

Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!

ORDER INFORMATION

Color   Product   Bundle   Art.No. 
 presto Steinschlag ÜL wb 1000  1 l  343735
 * no color identification possible

The presentation of colors may deviate from the original color.

EXAMPLES FOR USE

DISCLAIMER OF LIABILITY

This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. MOTIP DUPLI is let off the liability, unless the liability-based incident is caused by a fault incurred to MOTIP DUPLI.

For any further technical questions call our hotline +49 (0) 62 66 75-266 from Monday to Thursday from 9 h a.m. to 3 h p.m. or on Friday until 12 h p.m.

As of: March 28, 2012
This release replaces all eventually earlier issued versions.

 

PORUDŽBENI BROJEVI

Color   Product   Bundle   Art.No. 
 presto Steinschlag ÜL wb 1000  1 l  343735
 * no color identification possible

The presentation of colors may deviate from the original color.